B
HomeLibrariesCode AISearchProjectsBookmarksAddress
FeedbackHelp Desk
Calculators
All Calculators
Permits
Permit Fee
Egress
Occupant Load & Egress
Structural
Beam SpanConcrete VolumeExcavationDeck Footings
Electrical
Electrical LoadWire Size
Mechanical
HVAC Load
Fire Safety
Fire Resistance
General
Stair Layout
Elsewhere
Code LibraryDiagramsAssembliesChecklistsNeed a custom calculation? →
PricingLog in
Home / Calculators / Building Permit Fee Calculator

Lexington, Kentucky Building Permit Cost Calculator

Estimates permit cost in Lexington from the city's own published fee schedule — not a national average. Every figure is computed from a rule quoted verbatim from that document, and rules that cannot be computed honestly are shown as the published text instead of a number.

217 jurisdictions with fee schedules on file

Total cost of work, labor and materials

Used by cities that price per square foot

Fences and retaining walls

Electrical permits priced by the ampere

Building Permit

These lines are alternatives, not a running bill. Pick the one that describes your project and any percentage-based add-ons will be calculated from it.

○Single-family residence, rate per square foot
Flat fee $0.10
$0.10
○Single-family residence, minimum permit fee
Flat fee $150.00
$150.00
○Single-family residence, flat per-dwelling amount added to the square-foot charge
Flat fee $180.00
$180.00
○Residential plan review fee, due at plan submittal
Flat fee $25.00
$25.00
○Duplex, townhouse, apartment or condominium, flat amount per unit
Flat fee $100.00
$100.00
How this jurisdiction calculates the fee

Priced from the LFUCG Department of Environmental Quality and Public Works, Division of Building Inspection, Commercial and Residential Schedule of Fees, effective July 1, 2019 (document revised 10/27/2021). For a single-family residence the permit fee is ten cents per square foot of the project, subject to a $150 minimum, plus a flat $180 per dwelling. A separate residential plan review fee of $25 is due at the time of plan submittal. Duplex, townhouse, apartment and condominium work is charged at the same ten cents per square foot with a $150 minimum plus $100 per unit instead of the $180. Fees are doubled for work started without a permit.

Source: published fee schedule · Verified 11/2/2026

Deck Permit

These lines are alternatives, not a running bill. Pick the one that describes your project and any percentage-based add-ons will be calculated from it.

○Residential addition (includes decks), rate per square foot
Flat fee $0.10
$0.10
○Minimum permit fee, which governs any deck under 1,500 square feet
Flat fee $150.00
$150.00
○Typical 300 square foot deck (minimum applies)
Flat fee $150.00
$150.00
How this jurisdiction calculates the fee

Priced from the LFUCG Department of Environmental Quality and Public Works, Division of Building Inspection, Commercial and Residential Schedule of Fees, effective July 1, 2019 (document revised 10/27/2021). A deck is charged under the residential additions line, which the schedule states covers attached garages, decks and dormers: ten cents per square foot of the project, subject to a $150 minimum. Because most residential decks are well under 1,500 square feet, the $150 minimum governs in practice. Fees are doubled for work started without a permit.

Source: published fee schedule · Verified 11/2/2026

Electrical Permit

These lines are alternatives, not a running bill. Pick the one that describes your project and any percentage-based add-ons will be calculated from it.

○Electrical permit
Flat fee $10.00
$10.00
How this jurisdiction calculates the fee

A flat fee applies to each electrical permit.

Source: published fee schedule · Verified 11/10/2026

Fence Permit

These lines are alternatives, not a running bill. Pick the one that describes your project and any percentage-based add-ons will be calculated from it.

○Residential fence permit, flat fee
Flat fee $50.00
$50.00
○Commercial fence permit, flat fee
Flat fee $100.00
$100.00
How this jurisdiction calculates the fee

Priced from the LFUCG Department of Environmental Quality and Public Works, Division of Building Inspection, Commercial and Residential Schedule of Fees, effective July 1, 2019 (document revised 10/27/2021). A residential fence permit is a flat $50 regardless of length or height; a commercial fence permit is a flat $100. Fees are doubled for work started without a permit.

Source: published fee schedule · Verified 11/2/2026

Retaining Wall Permit

These lines are alternatives, not a running bill. Pick the one that describes your project and any percentage-based add-ons will be calculated from it.

How this jurisdiction calculates the fee

No dollar figure is published for a retaining wall permit. A permit is required: the LFUCG permit guide for fences and walls states that all fences and walls 24 inches or higher above grade must be permitted, and that a wall 48 inches or higher requires an engineer certification. However, the adopted Division of Building Inspection Schedule of Fees, effective July 1, 2019 (revised 10/27/2021), was read in full across all three pages and contains no retaining wall line item, and Code of Ordinances Sec. 5-29 contains no provision mentioning walls or retaining walls. The application is filed under the combined Fences/Walls category in the LFUCG online portal, but the schedule prices only Fences, Residential at $50 and Fences, Commercial at $100, and it would be an unsupported inference to carry either figure across to a retaining wall.

Source: published fee schedule · Verified 8/11/2026

Shed Permit

These lines are alternatives, not a running bill. Pick the one that describes your project and any percentage-based add-ons will be calculated from it.

○Residential accessory building (includes sheds), rate per square foot
Flat fee $0.10
$0.10
○Minimum permit fee, which governs any shed under 1,500 square feet
Flat fee $150.00
$150.00
○Typical 200 square foot shed (minimum applies)
Flat fee $150.00
$150.00
How this jurisdiction calculates the fee

Priced from the LFUCG Department of Environmental Quality and Public Works, Division of Building Inspection, Commercial and Residential Schedule of Fees, effective July 1, 2019 (document revised 10/27/2021). A shed is charged under the residential accessory buildings line, which the schedule states covers detached garages and sheds: ten cents per square foot of the project, subject to a $150 minimum. Because a shed is rarely over 1,500 square feet, the $150 minimum governs in practice. Fees are doubled for work started without a permit.

Source: published fee schedule · Verified 11/2/2026

Water Heater Permit

These lines are alternatives, not a running bill. Pick the one that describes your project and any percentage-based add-ons will be calculated from it.

○Only one new domestic water heater installed or replaced within a single building
Flat fee $50.00
$50.00
Base fee, residential one- and two-family units
$50 plus $14 for each plumbing fixture, appliance, or opening left for a plumbing fixture or appliance in the soil or waste pipe system; each domestic water heater; and each separately metered water and sewer service if more than one is to be installed
see rule
Base fee, buildings other than residential one- and two-family units
$50 plus $20 for each plumbing fixture, appliance, or opening left for a plumbing fixture or appliance in the soil or waste pipe system; each domestic water heater; each conductor opening; and each separately metered water and sewer service if more than one is to be installed
see rule
○Additional plumbing inspection beyond the five included with the permit
Flat fee $50.00
$50.00
How this jurisdiction calculates the fee

Under 815 KAR 20:050, the plumbing permit fee for residential one- and two-family units is a base fee plus a per-item charge, except that a single water heater installation or replacement within a building carries only the base fee.

Source: published fee schedule · Verified 11/11/2026

See the full write-up: Lexington building permit cost

Estimate only.Fee schedules change, and building departments set the final valuation and decide which fees apply to your scope. Confirm with the jurisdiction before budgeting. Lines marked “see rule” could not be computed from the published wording and are shown verbatim rather than guessed.