4115.01DESCRIPTION
Gravel or crushed stone particles meeting one of the aggregate durability classes listed below. Acquire aggregates from an approved source meeting the requirements of Materials I.M. 409. Unless stated otherwise on the source approval, coarse aggregate for Portland Cement Concrete shall be washed with sufficient agitation to cause material coatings to be separated and removed. A.
Class 2 Durability. No deterioration of pavements of non-Interstate segments of the road system after 15 years and only minimal deterioration in pavements after 20 years of age.
B.
Class 3 Durability. No deterioration of pavements of non-Interstate segments of the road system after 20 years of age and less than 5% deterioration of the joints after 25 years.
C.
Class 3i Durability. No deterioration of pavements of the Interstate Road System after 30 years of service and less than 5% deterioration of the joints after 35 years.
4115.02QUALITY
Meet the requirements of Tables 4115.02-1 and 4115.02-2 and Section 4109:
Coarse Aggregate for Portland Cement Concrete 4115.03
Aggregate Quality
Table 4115.02-1: Aggregate Quality Maximum Percent Allowed
Test Method
Abrasion (Cr. Stone)
50
AASHTO T 96
Abrasion (Gravel)
(may be increased by 0.1% for each 1% of particles with at least one fractured face)
AASHTO T 96
Alumina(a, b)
0.5
A Freeze
Iowa DOT Materials Laboratory Test Method No. 222 Iowa DOT Materials Laboratory Test Method No. 211, Method A
Clay Lumps and Friable 0.5 Materials I.M. 368 Particles
compliance. If the Alumina value fails, determine the A Freeze value for specification compliance.
Table 4115.02-2: Maximum Permissible Amounts of Objectionable Materials Maximum Percent Test Method Allowed Coal and carbonaceous shale 0.5 Materials I.M. 372 Objectionable Materials.
Total of all shale, similar objectionable materials, and coal combined
1.0
Materials I.M. 372
Organic Materials, except coal
0.01
Iowa DOT Materials Laboratory Test Method No. 215
Unsound chert particles retained on 3/8 inch sieve (Nonstructural concrete)
3.0
Materials I.M. 372
Unsound chert particles retained on 3/8 inch sieve (Structural concrete)
2.0
Materials I.M. 372
• • •
Note: Chert particle which break into three or more pieces when subjected to the freezing and thawing test will be considered unsound. Chert in aggregate produced from limestone sources is defined as unsound when any of the fractions of the crushed or uncrushed chert do not meet the soundness requirements.
4115.03GRADATION
Meet the requirements of Article 4109.02 and Table 4115.03-1:
4115.04
Coarse Aggregate for Portland Cement Concrete
Mix Class (Materials I.M. 529) D
Table 4115.03-1: Aggregate Gradations Mix Number Gradation Numbers (Materials I.M. 529) (Article 4109.02) 57, 57-6 3 or 5
A, B, C
2 to 8, V47B
3, 4, or 5
M
3, 4, or 5
A, B, C, M
V
4115.04 A.
AGGREGATE USE DURABILITY REQUIREMENTS. Meet the requirements of Table 4115.04-1:
Table 4115.04-1: Aggregate Use Durability Requirements Minimum Durability Specification Section Class Use Number Required 3i 2122, 2201, 2212, 2213, 2301, 2302, 2310, 2529, 2530 Interstate System Primary System Other
PCC Paved Shoulders, Base, Base Repair, Base Widening PCC Pavement, Widening, PCC Overlay, Finish Patches, and Bridge Approaches
X* X* X
2403
X
Structural Concrete
2406 (See 2403)
X
Concrete Structures
2407
X
Precast Units
2407, 2501 2412 (See 2403) Interstate and Primary System Other 2413 (See 2413.02, D, 1)
X X
Prestressed Units, Concrete Piles X
Concrete Bridge Decks
2414 (See 2403)
X
Concrete Railings
2415 (See 2403)
X
Concrete Box, Arch, & Circular Culverts
X
Bridge Deck Surfacing, Repair, & Overlay
2416 (See 4145)
X
Rigid Pipe Culverts
2424
X
Shotcrete
2503 (See 2403)
X
Storm Sewers (Catch Basins, Intakes, & Utility Access)
2505 (See 2403)
X
Guardrails (Concrete End Anchorage)
2511, 2515 (See 2403)
X
PCC Sidewalks, Paved Driveways
2512 (See 2403)
X
PCC Curb & Gutter
2513 (See 2403)
X
Concrete Barrier
2516 (See 2403) 2517 Primary System Other 2522 (See 2403)
X
Concrete Walls and Steps
X
Railroad Approach Sections X X
Tower Lighting (Concrete Footings &
Coarse Aggregate for Portland Cement Concrete 4115.05
Foundations) Highway Lighting (Concrete Footings & Foundations) Highway Signing (Concrete Footings & 2524 (See 2403) X Foundations) Traffic Signals (Concrete Footings & 2525 (See 2403) X Foundations) * For patches and PCC base repair, Class 2 durability or better aggregate will be required if the existing pavement was constructed of Class 2 or lower durability aggregate. If the existing pavement was constructed of Class 3 or Class 3i durability aggregate, use Class 3 aggregate or better and Class 3i aggregate, respectively, in the repair. 2523 (See 2403)
B.
X
Use crushed stone coarse aggregate for: • Aesthetic concrete cast with form liners or rustication. This includes Mechanically Stabilized Earth (MSE) walls and noise walls. • Concrete receiving color sealer or texture treatments. • Concrete for precast box culverts that are to receive color sealer.
4115.05
COARSE AGGREGATE FOR BRIDGE DECK SURFACING, REPAIR, AND OVERLAY. Acquire from a Class 3 durability or better source meeting the following requirements: A.
Quality. Meet the requirements of Tables 4115.05-1 and 4115.05-2: Table 4115.05-1: Aggregate Quality Aggregate Quality
Maximum Percent Allowed
Test Method
Abrasion
AASHTO T 96
Alumina(a, b)
0.5
Iowa DOT Materials Laboratory Test Method No. 222
A Freeze
Iowa DOT Materials Laboratory Test Method No. 211, Method A
Absorption
2.5
Iowa DOT Materials Laboratory Test Method No. 201
(a)
(b)
If the Alumina value passes, the A-Freeze is not needed for specification compliance. If the Alumina value fails, determined the A Freeze value for specification compliance. Alumina does not apply to gravel.
Table 4115.05-2: Maximum Permissible Amounts of Objectionable Material Maximum Percent Objectionable Materials Test Method Allowed Unsound chert particles 0.5 Materials I.M. 372 retained on No. 4 sieve Total of all unsound chert, shale, coal, and iron combined
1.0
Materials I.M. 372
Organic Materials, except coal
0.01
Iowa DOT Materials Laboratory Test Method No. 215
4116.04
Class V Aggregate for Portland Cement Concrete
Note: Unsound chert particles are defined in Article 4115.02.
B.
Gradation. Meet the gradation requirements for Gradation No. 6 of the Aggregate Gradation Table, Article 4109.02.