DUST CONTROL AND WATERING
PART 1 GENERAL
1.1SECTION INCLUDES
A.Requirements for dust control and pre-wetting.
1.2RELATED SECTIONS Not Used
1.3REFERENCES Not Used
1.4DEFINITIONS Not Used
1.5SUBMITTALS Not Used
PART 2 PRODUCTS
2.1WATER
A.Free of dirt, silt, and other detrimental matter in adequate quantities for
dust control and watering requirements.
2.2EQUIPMENT
A.Water distribution system – Self-propelled, pressure distributor with a
spray system, equipped with a positive shut-off control.
1.Pressure pump must have the capacity to apply the whole load
uniformly.
B.Water truck – 1,000 U.S. gallons minimum capacity, with the capacity
clearly and permanently marked on the tank.
1.Engineer may require Contractor to verify capacity.
Dust Control and Watering
PART 3 EXECUTION
3.1APPLICATION
A.Apply water for dust control in quantities and locations as needed to
maintain environmental compliance and pre-wet base materials.
1.Dust control may be required at any time.
2.Do not waste water.
END OF SECTION
Dust Control and Watering
Get an email when 01572 changes
Utah revises spec sections through supplementals and new editions. We check this one every week and email you the day it changes. Free, no account.
Source: Utah Standard Specifications for Road and Bridge Construction, 2026 Edition. Pages 205–206 of 1,331. View official source ↗