B
HomeLibrariesCode AISearchProjectsBookmarksAddress
FeedbackHelp Desk
Libraries
Estimate & calculate
CalculatorsChecklists
PricingLog in
Division 200 — Stabilized Subgrade, Base and Shoulders

211Geofoam Lightweight Embankment Fill

KS · 2015 Standard Specifications✓ Full text on BuildSpecBook pages 141–141 Save this section

Ask about Section 211

Get a cited answer from the section text. Click the citation to check it.

One cited answer a day is free. Start a 14-day trial for unlimited, no card required.

211.1 Description

Provide and install the geofoam lightweight expanded polystyrene (EPS) fill at the embankment locations shown in the Contract Documents. BID ITEM UNITS Geofoam-Fill Cubic Yard

211.2 Materials

Provide materials that comply with the applicable requirements. Concrete ................................................................................................................ SECTIONS 401 & 402 Aggregates for Concrete Not On Grade ................................................................ SECTIONS 1102 Geofoam Lightweight Embankment Fill ............................................................... DIVISION 1700

211.3 Construction Requirements

Fabricate the expanded polystyrene in standard sizes that are typically 4-foot wide by 2.5-foot thick by 8 to 16-foot long blocks. Trim the blocks prior to arriving at the job site w ith a uniformly even surface with a tolerance of ¼ inch in 10 feet. Cut the blocks using a saw unless alternative cutti ng methods have been approved by the Engineer. Provide temporary weighting and guying down of the lightweight material as required until all blocks are built into a homogeneous mass. Construct the geofoam-fill in successive layers of bloc ks with the block’s long axis alternating by 90° and offsetting blocks by half their widths to prevent the continuation of joints within the polystyrene mass. Connect the polystyrene blocks w ith gripper plates. Place gripper pl ates between horizontal layers of geofoam as required. Do not damage the EPS during construction or storage. Protect the EPS from petroleum based solvents, flame, and other ignition sources. Do not expose the E PS to direct sunlight. Keep the expanded polystyrene covered with a light-colored opaque tarp.

211.4 Measurment and Payment

The geofoam-fill will be measured by the cubic yard. Payment for "Geofoam-Fill" at the contract unit price is full compensation for the specified work.

Get an email when 211 changes

Kansas revises spec sections through supplementals and new editions. We check this one every week and email you the day it changes. Free, no account.

Source: Standard Specifications for State Road and Bridge Construction, 2015 Edition. Pages 141–141 of 978. View official source ↗

Ask about this section

Scoped to Kansas KDOT Standard Specifications for Road & Bridge Construction, Section 211 — Geofoam Lightweight Embankment Fill. Every answer cites the section it came from, with a verification date — don’t trust a percentage, click the citation.