B
HomeLibrariesCopilotSearchProjectsBookmarks
FeedbackHelp Desk
Libraries
Building Codes
Code LibraryIBC — BuildingIRC — ResidentialIFC — FireIPC — PlumbingIMC — MechanicalIFGC — Fuel GasIECC — EnergyNEC — ElectricalModel Codes
Specifications
CSI SpecificationsDOT SpecsTransit SpecsUSACE
Standards
TransportationRailroadFire SafetyAccessibilityStructural
Tools & References
DiagramsAssembliesProductsCalculatorsChecklistsPermits
PricingLog in
General Conditions

00860Longitudinal Pavement Markings - Paint

OR · 2024 Standard SpecificationsBook pages 947947View official source ↗

00860.90 881 Section 00860 - Longitudinal Pavement Markings - Paint

Description

00860.00Scope - In addition to the requirements of Section 00850, install painted longitudinal

pavement markings according to the following Specifications.

Construction

00860.45Installation - Apply painted longitudinal pavement markings as follows:

• Apply two separate applications of painted longitudinal pavement markings. Retrace the second application directly over the fi rst application, within 1/16 inch as follows: • Apply the second application after 2 hours but within 48 hours of the first application. • For yellow colored markings that delineate two-way traffic, apply the second application in the opposite direction of the first application. For yellow colored markings on one-way Roadways, apply the second application in the same direction of the first application. For white colored markings, apply the second application in the same direction of the first application. • Apply each painted marking application at a thickness of 15 mils wet, equivalent to 17 gallons per mile for a 4 inch wide solid stripe. • Apply reflective elements for each application at a minimum rate of 5 pounds per gallon of paint. Embed, by means of paint wicking, a minimum of 80 percent of the reflective elements in the paint to a minimum depth of 50 percent of their diameter. Minimum initial retroreflectivity shall be the following:

• White - 250 mcd/m 2/lx • Yellow - 200 mcd/m2/lx

Measurement

00860.80Measurement - The quantities of painted longitudinal pavement markings will be

measured on the length basis. Painted longitudinal pavement markings will be based on a nominal line width of 4 inches. If the width of the line is other than 4 inc hes, measurement will be adjusted by converting to an equivalent length of nominal 4 inch line on a proportionate area basis. Measurement will be the actual stripe. Gaps between skip stripes will not be measured.

Payment

00860.90Payment - The accepted quantities of painted longitudinal pavement markings will be paid

for at the Contract unit price, per foot, for the item "Longitudinal Pavement Markings - Paint".

Payment will be payment in full for furnishing and placing all Materials, and for furnis hing all Equipment , labor, and Incidentals necessary to complete the Work as specified.

Source: Oregon Standard Specifications for Construction, 2024 Edition. Pages 947947 of 1,268.