Page 5951040 STEEL SHEET PILING
1040.1 Steel Sheet Piling
Steel sheet piling will be of the style, dimensions, and mass specified. Steel sheet piling will conform to the requirements of ASTM A 328; ASTM A709, Grade 50; ASTM A690, ASTM A857, or as specified. The piling will be true, straight, and uniform in section. The side of each piece will be furnished with an interlock that is continuous for the full length of the sheet. Page 5961050 STEEL SHEETING
1050.1 Scope
This specification covers the fabrication of galvanized steel sheet products.
1050.2 Requirements
The galvanized steel used in fabricated metal products will conform to ASTM A929. The sheeting will be true, straight, and uniform in section. The sheeting will be galvanized at a rate of 2 ounces per square foot total for both sides. The steel sheeting for fabricated lightweight sheet piling and other items in which interlock is specified will consist of corrugated or flat steel sheets which, when properly driven or installed, will interlock with adjacent sheets for the full length of the sheet. The interlock will be formed by bending the metal 180 degrees, leaving an opening to allow free slippage of adjoining sheets. The specified metal products will be fabricated to the strength, shape, and dimensions shown in the plans and to avoid cracking or breaking the spelter coating on the galvanized sheets.
STEEL SHEET PILING in other states
Get an email when 1040 changes
South Dakota revises spec sections through supplementals and new editions. We check this one every week and email you the day it changes. Free, no account.