B
HomeLibrariesCode AISearchProjectsBookmarksAddress
FeedbackHelp Desk
Libraries
Estimate & calculate
CalculatorsChecklists
PricingLog in
Structures

516Paint Repair

WY · 2021 Standard Specifications✓ Full text on BuildSpecBook pages 518–0 Save this section

Ask about Section 516

Get a cited answer from the section text. Click the citation to check it.

One cited answer a day is free. Start a 14-day trial for unlimited, no card required.

Paint Repair

516.1DESCRIPTION

1 This section describes the requirements for paint repair on structural steel.

516.2MATERIALS

1 Provide materials in accordance with the following:

Material Subsection Paint 809

516.3EQUIPMENT—V acant

516.4CONSTRUCTION

1 Clean and paint deteriorated paint systems on existing structural steel to limits specified. When required, paint steel piling after exposing to 12 in [300 mm] below ground. Clean and paint from this point to the bottom of the pile cap.

2 Prepare structural steel surfaces for painting in the following sequence:

1.Wire-brush, abrade, or scrape with hand or power tools all areas of heavy rusting,

deep rust pitting, loose paint, or built-up foreign matter.

2.Remove oil, grease, and contaminants from the surface with clean rags wetted

with cleaning solvent.

3.Using rags wetted with clean, uncontaminated water, remove dirt, oxidation, and

other contaminants from steel areas. Use a minimal amount of water for cleaning. Obtain the engineer’s approval for cleaning by other methods.

4.Let surfaces air-dry before painting. Compressed air, free of water and oil, may

be used to accelerate drying.

3 Ensure that the final prepared surface is free of oil, grease, dirt, soluble contaminants, moisture, rust scale, loose mill scale, loose rust, and loose paint or coatings. Tight mill scale and tightly adhered rust, paint, and coatings may remain.

4 Paint structural steel in accordance with Subsection 501.4.2.8.3, Field Paint Application, for the type of paint system selected, using the color specified.

Paint Repair SECTION 516

5 The department does not require a prime coat when specifying epoxy-mastic paint. Use aluminum-colored epoxy-mastic paint.

6 Protect other portions of the structure, traffic, and surrounding property from paint overspray. Correct overspray damage at no additional cost to the department.

516.5MEASUREMENT and PAYMENT

1 The engineer will measure:

1.Paint Repair—Bridge Railing as one complete unit or by the foot [meter] of railing

painted.

2.Paint Repair—Structural Steel and Paint Repair —Steel Piling as one complete unit

or by the square foot [square meter] of surface area painted.

2 The department will pay as follows:

Pay Item

Pay Unit Measure to the Nearest Pay to the Nearest Paint Repair— Bridge Railing LS, FT [m] LS, 0.1 ft [0.05 m] LS, FT [0.5 m] Paint Repair— Steel Piling LS, SF [m

] LS, 0.1 ft [0.05 m] LS, SF [0.1 m

] Paint Repair— Structural Steel LS, SF [m

] LS, 0.1 ft [0.05 m] LS, SF [0.1 m

]

DIVISION 600

M iscellaneous Construction

Referenced in this section

Get an email when 516 changes

Wyoming revises spec sections through supplementals and new editions. We check this one every week and email you the day it changes. Free, no account.

Source: Wyoming Standard Specifications for Road and Bridge Construction, 2021 Edition. Pages 518–0 of 771. View official source ↗

Ask about this section

Scoped to Wyoming WYDOT Standard Specifications for Road & Bridge Construction, Section 516 — Paint Repair. Every answer cites the section it came from, with a verification date — don’t trust a percentage, click the citation.