1052GALVANIZED SHEET METAL

NE · 2017 Standard Specifications✓ Full text on BuildSpecBook pages 924–924 Save this section

Ask about Section 1052

Get a cited answer from the section text. Click the citation to check it.

One cited answer a day is free. Start a 14-day trial for unlimited, no card required.

- 890 - SECTION 1052 -- GALVAN IZED SHEET METAL

1052.01 Description

1.Galvanized sheet metal shall conform to the requirements of ASTM A 653/A 653M. The sheet metal shall be at least 24 gauge [0.028 inch (0.70 mm)] thick and have a coating weight conforming to coating designation G 115/Z 350.

1052.02 Acceptance Requirements

1.Galvanized sheet metal will be accepted based on the requirements of this Section and a ma nufacturer's certified test report showing compliance with the requirements in this Section. - 891 - SECTION 1053 -- SHEET ZINC

1053.01 Description

1.Sheet zinc shall conform to the requirements of ASTM B 69, Type II. Zinc sheet shall be at least 24 ga uge [0.028 inch (0.70 mm)] thick.

1053.02 Acceptance Requirements

1.Sheet zinc will be accepted based on the requirements of this Section and a manufacturer's certificat e of compliance indicating compliance with the requirement in this Section.

Get an email when 1052 changes

Nebraska revises spec sections through supplementals and new editions. We check this one every week and email you the day it changes. Free, no account.

Source: Nebraska Standard Specifications for Highway Construction, 2017 Edition. Pages 924–924 of 1,048. View official source ↗

← Previous

1051 IRON CASTINGS

1053 SHEET ZINC

Ask about this section

Scoped to Nebraska Standard Specifications for Highway Construction, Section 1052 — GALVANIZED SHEET METAL. Every answer cites the section it came from, with a verification date — don’t trust a percentage, click the citation.