613Latex Emulsion Paint for Concrete

Latex Emulsion Paint for Concrete

613.1DESCRIPTION

1 This section describes the requirements for latex emulsion paint.

613.2MATERIALS

1 Provide materials in accordance with the following: Material Subsection Latex Emulsion Paint 809.8

613.3EQUIPMENT—V acant

613.4CONSTRUCTION

613.

4.1Surface Preparation

1 Give concrete surfaces a rubbed finish in accordance with Subsection 513.4.12, Finishing Concrete Surfaces. 2 Clean surfaces before painting. 3 Where applicable, protect concrete surfaces that have been or will be painted with latex from structural steel paint overspray. 613.

4.2Application

1 Allow the paste from surface preparation to set at least 24 hours. Saturate the surface with water and paint while damp but not showing free water. Do not mix sand with paint. Apply at least two coats at a rate of approximately 350 ft²/ gal [9 m²/L] for the first coat and from 400 ft²/gal [10 m²/L] to 500 ft²/gal [12 m²/L] for the second. Apply additional coats as necessary for uniform coverage and appearance. Paint when the air temperature is at least 50 °F [10 °C] and only with rollers or brushes.

613.5MEASUREMENT and PAYMENT

613.

5.1General

1 The engineer will measure Ltx Emulsion Paint (Conc) as a complete unit in place.

Latex Emulsion Paint for Concrete SECTION 613 2 The department will pay as follows: Pay Item Pay Unit Measure to the Nearest Pay to the Nearest Ltx Emulsion Paint (Conc) LS LS LS