3314.1SCOPE
Provide rounds, squares, hexagons, or flats as required by the Contract.
3314.2REQUIREMENTS
A Type I — Carbon Bar Steel Provide cold-finished carbon bar steel meeting the requirements of ASTM A108, Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished, Grade C1035, and the following strength requirements, unless the Contract requires otherwise:
a maximum dimension across flats no greater than 3 inches:
with a maximum dimension across flats greater than 3 inches:
B Type II — Alloy Bar Steel Provide cold-finished alloy bar steel meeting the requirements of ASTM A108, Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished, and the corresponding annealed and cold-finished Grade AISI 4140 or Grade AISI 4142 and the following strength requirements, unless the Contract requires otherwise:
with a maximum dimension across the flats no greater than 3 inches:
with a maximum dimension across the flats greater than 3 inches:
C Type III — Heat Treated Alloy Bar Steel (Rounds) Provide cold-finished pre-heat treated alloy bar steel with the base Material meeting the requirements of ASTM A108, Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished, for corresponding Grade AISI 4140 or Grade AISI 4142. D Type IV — Corrosion Resisting Cold Finished Rounds Provide cold-finished stainless steel rounds for use as Bridge pins meeting the requirements of ASTM A276, Standard Specification for Stainless Steel Bars and Shapes , Type 316, annealed and center- less ground.
3314.3SAMPLING AND TESTING — BLANK
Get an email when 3314 changes
Minnesota revises spec sections through supplementals and new editions. We check this one every week and email you the day it changes. Free, no account.