Art. 1033.01 Drain Pipe, Tile, and Wall Drain For drainage and utility castings, temporary rubber ramp material shall be according to the following. Property Test Method Requirement Durometer Hardness, Shore A ASTM D 2240 75 15 Tensile Strength, psi (kPa) ASTM D 412 300 (2000) min. Elongation, % ASTM D 412 90 min. Specific Gravity ASTM D 297 1.0 - 1.3 Brittleness, F (C) ASTM D 746 -40 (-40)
1033.02 Temporary Plastic Ramps. Temporary plastic ramps for butt joints
shall be made of high density polyethylene and the Contractor shall furnish a manufacturer’s certification of test results meeting the following requirements. Physical Property Test Method Requirement Melt Index, g/10 min ASTM D 1238 8.2 Density, g/cc ASTM D 1505 0.965 Tensile Strength @ Break, psi (MPa) ASTM D 638 2223 (15) Tensile Strength @ Yield, psi (MPa) ASTM D 638 4110 (28) Elongation @ Yield, % 1/ ASTM D 638 7.3 min. Durometer Hardness, Shore D ASTM D 2240 65 Heat Deflection Temperature, 66 psi, F (C) ASTM D 648 176 (80) Low Temperature Brittleness, F50, F (C) ASTM D 746 < -105 (< -76) 1/ Crosshead speed -2 in./minute MASONRY AND DRAINAGE ITEMS SECTION 1040. DRAIN PIPE, TILE, AND WALL DRAIN
1040.01 Drain Tile. Drain tile shall be according to the requirements of
ASTM C 4. The tile furnished shall be that designated as heavy-duty drain tile. The maximum length of the units shall be 24 in. (600 mm).
1040.02 Clay Pipe. Extra strength clay pipe, extra strength perforated clay
pipe, and clay sewer pipe shall be according to the requirements of ASTM C 700.
1040.03 Polyvinyl Chloride (PVC) Pipe. Acceptance testing of PVC pipe and
fittings shall be accomplished during the same construction season in which they are installed. The section properties shall be according to the manufacturer pre- submitted geometric properties on file with the Department. The manufacturer shall submit written certification that the material meets those properties. The pipe shall meet the following additional requirements.
a.PVC Pipe. The pipe shall be according to AASHTO M 278 or ASTM F 679, except it shall be made of PVC plastic having a minimum cell classification of 12454-C or 12364-C, as defined in ASTM D 1784.
Get an email when 1033 changes
Illinois revises spec sections through supplementals and new editions. We check this one every week and email you the day it changes. Free, no account.
Source: Illinois Standard Specifications for Road and Bridge Construction, 2022 Edition. Pages 935–935 of 1,217. View official source ↗